[Avedis53]

Since you don't list your pertinent car information like we ask new members to do, that may be it. If you have an RS, you'll need to enable Bit 6 for EWG.

 

[HQ50V]

Sounds about right. There's a full ewg thead on n54tech where Terry shows what to tweak based on results.

I READ ABOUT A HUNDRED PAGES AND MY EYES STARTED TO GET BLURRY SO I GAVE UP. THE POST I READ WAS FROM 2017 I BELEIVE, SO I WASNT SURE IF THINGS HAVE CHANGED BECAUSE OF UPDATED FIRMWARE..

 

[HQ50V]

Since you don't list your pertinent car information like we ask new members to do, that may be it. If you have an RS, you'll need to enable Bit 6 for EWG.


MY BAD, WASNT AWARE OF THAT. ITS A NON RED SPORT 2018. I APPRECIATE THE INFO.

 

[Avedis53]

NEW MEMBERS PLEASE READ THIS!

Greetings new members of the Q50 forum! In order for you to get the most out of your forum experience, there are a couple of things you should do first and foremost. One - Spend some time reading forum topics of interest to you before posting. If you are looking to mod, maintain, or discuss...

www.infinitiq50.org

 

[Ddnspider]

I READ ABOUT A HUNDRED PAGES AND MY EYES STARTED TO GET BLURRY SO I GAVE UP. THE POST I READ WAS FROM 2017 I BELEIVE, SO I WASNT SURE IF THINGS HAVE CHANGED BECAUSE OF UPDATED FIRMWARE..

The EWG wire thread isn't the 200+ page thread. It's a separate thread.

 

[shakeluxe31]

93oct when I posted my logs. Also have run E30 with fuel wires, when I got it dyno'd and put out 423whp 450tq on a custom Map 6 run

what map 6 should i run on 93 octane and stock jb4. doing ams downpipes soon as well

 

[BOP Leader]

Please can someone post what pins are required to fit the DB25 connector? I'd like to manufacture my own fuel wires.

 

[ptatohed]

Please can someone post what pins are required to fit the DB25 connector? I'd like to manufacture my own fuel wires.

Does the picture help?

 

[Avedis53]

Don't forget the 1K Ω resistor on the driver's side lead if you're making your own set.